Escape Pod - 4

Bit more progress here - after a LOT of swearing.

The usual trouble i have with curved surfaces stuck once again - how the hell do you cut something square that'll look square and not cockeyed once on the hull?

Getting round it by not putting on anything complex, sticking to simple lengths of plasticard.

I'm dotting them randomly around the hull as superglue isn't sticking to the material of the jar, but a bit better to the plastic label.

So bung a load of plasticard to the label, then glue onto the plasticard.

There's a greeblie in the middle of the hatch as this stage is deathly dull and i wanted to do something more productive.